Table of Contents SERVICES OVERVIEW GUIDE Preface About This Guide About This Guide Audience List of Technical Publications Searching for Information To search for specific information in this guide To search for specific information in multiple documents Technical Support Services Overview In This Section In This Section Introduction Service Types Service Policies Multipoint Shared Queuing Ingress Queuing Modes of Operation Ingress Service Queuing Ingress Shared Queuing Ingress Multipoint Shared Queuing Alcatel-Lucent Service Model Service Entities Customers Service Access Points (SAPs) SAP Encapsulation Types and Identifiers Ethernet Encapsulations Default SAP on a Dot1q Port QinQ SAPs Services and SAP Encapsulations SAP Configuration Considerations G.8032 Protected Ethernet Rings Service Distribution Points (SDPs) SDP Binding Spoke and Mesh SDPs SDP Using BGP Route Tunnel SDP Keepalives SDP Administrative Groups SDP Selection Rules SAP & MPLS Binding Loopback with MAC Swap Class-Based Forwarding Application of Class-Based Forwarding over RSVP LSPs Operation of Class-Based Forwarding over RSVP LSPs Multi-Service Sites G.8031 Protected Ethernet Tunnels OAM Considerations QoS Considerations Mirroring and Lawful Intercept Considerations Support Service and Solution Combinations LAG Emulation using Ethernet Tunnels G.8032 Ethernet Ring Protection Switching Overview of G.8032 Operation Ethernet Ring Sub-Rings Virtual and Non-Virtual Channel Lag Support OAM Considerations Support Service and Solution Combinations Internal Objects Created for L2TP and NAT Ethernet Unnumbered Interfaces Service Creation Process Overview Deploying and Provisioning Services Phase 1: Core Network Construction Phase 2: Service Administration Phase 3: Service Provisioning Configuration Notes General Configuring Global Service Entities with CLI Service Model Entities Basic Configuration Configuring Multi-Service-Sites Configuring Multi-Service-Sites Configuring an SDP SDP Configuration Tasks Configuring an SDP Configuring a Mixed-LSP SDP Ethernet Connectivity Fault Management (ETH-CFM) Facility MEPs Common Actionable Failures General Detection, Processing and Reaction Port-Based MEP LAG Based MEP Tunnel Based MEP Router Interface MEP Hardware Support ETH-CFM and MC-LAG ETH-CFM and MC-LAG Default Behavior Linking ETH-CFM to MC-LAG State ETH-CFM Features CCM Hold Timers CCM Interval Service Management Tasks Modifying Customer Accounts Deleting Customers Modifying SDPs Deleting SDPs Global Services Command Reference Command Hierarchies Customer Commands MRP Commands Service System Commands Oper Group Commands Pseudowire (PW) Commands SDP Commands SAP Commands Ethernet Ring Commands ETH-CFM Configuration Commands ETH Tunnel Commands Show Commands Tools Perform Commands Global Service Configuration Commands Generic Commands Customer Management Commands Service System Commands MRP Commands Oper Group Commands Pseudowire Commands SDP Commands SDP Keepalive Commands Ethernet Ring Commands ETH-CFM Configuration Commands ETH-Tunnel Commands Tools Perform Commands Show, Clear, Debug, Commands In This Chapter Show Command Index Services Show Commands Service Commands ETH-CFM Show Commands Common CLI Command Descriptions In This Chapter Common Service Commands Standards and Protocol Support
